whewines.blogg.se - Crestron simpl jamming signals

I wanted to better understand this and know if I'm going about it the wrong way.

So then power is only triggered by my OR.

Using an OR and entering two distinct signals as inputs (for example power_tablet and power_rs232) and whenever either one goes high it activates the real "power" signal I need.

Doubling all commands, so then I have separate digital signals such as "power" and "pwoer" and add those as separate triggers to the same command (such as adding two lines in my serial i/o that are identical but one is triggered by power and one by pwoer).

I understand that this is the case, but my question is: what is the common workaround for this issue. It happens often that I want to issue a command both from a touchpanel (for example) AND from an RS-232 feedback (or automatically at the start of the system, etc.) and it says that the digital signals I'm using cannot be jammed together (they are already being triggered by something else). I know that a digital signal such as "power" can be applied to multiple commands (such as send RS-232 commands, enable some SIOs, send some LAN commands, one-shot some relays etc.), but most of the times, I cannot seem to trigger my "power" from multiple locations. It's a simple question but I can't figure it out myself, and it bugs the hell out of me:

So please forgive me if this has been posted before but I did a lot of reading and youtubing and I can't find someone who is addressing this directly in any tutorial. Just visit the Crestron Online Training section of the Crestron website.First of all, I'm very new to Simpl. I highly recommend that you investigate taking authorised Crestron programming training now offered through CTI. This Crestron programming tutorial is not intended to replace official Crestron programming classes. The menu on the left is also presented (top down) in first to last page order - so you could just click one after the other. Use your browser's "Forward" and "Back" keys to move through this Crestron programming tutorial. This will take you to the next page in the Crestron programming tutorial. This Crestron programming tutorial is written in an e-book format so all you need to do is to keep clicking the "Next item" link at the bottom of each page.

Test and troubleshoot Crestron programs using Crestron Viewport and Crestron Test Manager.

Upload Crestron control code into a Crestron CP2E controller.

Create a simple Crestron control program.

Upload your project to a Crestron touch panel.

Modify Crestron touch panel page properties.Create pages within a Crestron Vision Tools Pro-e project.Create a simple "my first button" Crestron project.Start a Crestron Vision Tools Pro-e touch screen project.After you have completed this Crestron programming tutorial, you will have learned how to: